Casio XJ-S31 - Manual (Page 19)

19
About the “Signal Specific” Setting Unit
For the items that have “Signal Specific” in the “Setting Unit” column of the above table,
the setting is saved for the specific type of signal (XGA/60Hz, SXGA/60Hz, etc.) that is
being input when the setting is performed, and not for a specific input source.
Vertical
Position RCV Signal
Specific Use this sub-menu to adjust the vertical position of the
input source image within the projection area.
Horizontal
Position RCV Signal
Specific Use this sub-menu to adjust the horizontal position of the
input source image within the projection area.
Frequency R Signal
Specific When vertical bands appear in the projected image while
RGB is selected as the input source, it means that the
frequency setting is not correct. When this happens, use
this setting to adjust the frequency manually.
Important!
If, for some reason, your manual frequency settings
cause the image input from the computer to
disappear from the projection, you can press the
[AUTO] key to perform an auto adjust operation,
which should cause the image to appear.
Phase R Signal
Specific When there is flickering in the projected image while RGB
is selected as the input source, it means that the phase
setting is not correct. When this happens, use this setting
to adjust the phase manually.
Video Mode RC V Source
Specific This setting is valid when VIDEO is selected as the input
source. Use it to select a mode that is optimized for
movies or still images.
Normal *:
Optimized for movies.
Still Image:
Optimized for still images. In particular, this setting should
be used when projecting still images from a digital
camera connected to the projector’s VIDEO terminal.
Restore Menu
Defaults RCVU Source
Specific Use this sub-menu to return all of the sub-menu items on
the Image Adjustment main menu to their initial default
settings.
z Restoring menu defaults when there is no input signal
will restore defaults for the currently selected input
source.
z “Image Adjustment” main menu “Vertical Position”,
“Horizontal Position”, “Frequency”, and “Phase” defaults
can be restored for the current signal type (XGA/60Hz,
SXGA/60Hz,etc.) only.
Setting Name Input
Setting
Unit
Description