JVC CS-XM620 User Manual

Cs-xm620, Car stereo speaker, Specifications

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

JVQ

CS-XM620

Thank you for purchasing JVC Car Stereo Speakers.

For the secure installation and perfect operation of your speakers,

please read the following carefully.

CAR STEREO SPEAKER

Specifications

Type:

16 cm (6-1/2") 2-Way Coaxial Speaker

Power Handling Capacity:

240 W (Peak Power) 40 W. rms

impedance:

4Q

Magnet Mass:

182 g (6.4 oz)

Mass:

0.63 kg (1.4 lbs)

For Proper Installation and Use

Install the speakers following this manual so as to prevent them from
slipping accidentally out of position due to the repeated impact such as
opening and closing doors or tossing and bumping of the vehicle.
Set the wiring firmly on the floor of the vehicle, taking the utmost care not

to break wires while installing.

When installing the speakers in the doors, keep reasonable play to the
wires. If clipping or clamping the wires too much, they will get pinched in

between the door and body of the vehicle when opening and closing door.

Since the speaker installed in the door is positioned at the foot level, be
careful not to damage the speaker by giving it an inadvertent kick. Check
the water outlet at the bottom of the door occasionally to ensure that it
drains well, leaving no rainwater inside the door.
Before connecting the speakers to the amplifier, turn off the power of the

amplifier. If it is turned on when connecting, a click noise will be generated
and it may damage the speakers.
When cleaning the speakers, use a soft cloth and wipe the surface gently.

Do not apply thinner or solvent.

Howto Install

1. Determine the place to install the speakers. (Fig. 1)

• Take enough space around the speakers considering their dimensions.
• Make sure the speakers are fitted in the rear tray without interfering any

parts of the vehicle.

2. Make the speaker holes and screw holes using the paper pattern on the

packing box.

3. Wire the speakers. (See "Connection ")

4. Mount the speakers and grilles in the rear tray. (Fig .2)

• You can also install the speakers in other places than

the rear tray shown in Fig .3 and Fig .4

* Mounting screws, speed clips and speaker cord

is not included.

r

Design and specifications are subject to change

without notice.

Stereo/Amplifier

Stereo/Ampiificator

Advertising
Table of contents