Toshiba KV-5124A - Manual (Page 14)

Recording in Various Ways
This unit employs a multifunction recording system so that it can be widely used for various recording functions. Carefully read
the description given here and become familiar with the operation of this unit.
Function Selection Operation Remarks
Record Mode Lock/
Recording after Power
Failure REC LOCK/RESTART
switch ON
* The record mode is
locked during
recording so that
other buttons and
switches cannot
operate.
* To dear the recording mode,
press the STOP button after
setting the REC LOCK/RESTART
switch to "OFF".
REC lock ;
RESTART
□D
* Control enters the
recording mode
automaticaily on
recovery from a
power failure.
** If the power failure lasts less
than 7 days, then the date, time
and recording time mode will be
stored in the memory, and
recording will be resumed
automatically after power is
restored.
REC LOCK/RESTART
switch center position
REC lock ;
RESTAJiT
(ID
►ON
***The record mode is
unlocked so that other
buttons and switches
can operate.
• For recovery from a
power failure, take the
same procedure as in ^.
* Take the same procedure as
in if recovery from a power
failure is within 7 days.
REC LOCK/RESTART
switch OFF
REC LOCK;
RESTART
fflD
• Use the same record
mode as in ***.
• Controls does not
enter the recording
mode automatically on
recovery from a
power failure.
Auto Repeat Recording Recording on the same
cassette repeatedly. Set the REPEAT switch
to ''ON".
• When the tape end is detected,
recording is started again from
the beginning of the tape, at The
same speed mode that was set
originally.
• If the power fails during
recording, recording mode will be
automaticaily resumed when the
power is restored.
Sounding at end of tape To ensure changing of
the cassette Set the BUZZER switch
to "ON".
• When the end of the tape is
detected, an electronic buzzer
sounds continuously, and the
counter display blinks.
• Press ary one of CONTROL
buttons to stop the buzzer and
blinking of the counter display.
Timer Recording To record at a specific
time by setting weekday
and time. Set the timer recording
start and stop time, and
weekday. Then press the
TIMER button.
* Timer recording can be performed
for 1 5 programs in total; two
programs for everyday from
Monday through Sunday and one
program for a specified time of
day through the week.
Notes
Linder the foltowing conditions, the recording mode will not
be resumed even if the power is restored.
- A mode other than recording is set with both the
REPEAT
and REC LOCK/RESTART switches ON.
If an alarm signal is entered in AUTO Repeat mode, Repeat
Recording is disabied- In this case, press the
ALARM RECALL
button and then press the RESET button to reset the aiarm
counter display.
13