Chrysler 2004 300M - Manual (Page 222)

Fluid Level Check
The fluid level in the automatic transaxle should be
checked whenever the vehicle is serviced. Operation with
an improper fluid level will greatly reduce the life of the
transaxle and of the fluid.
Procedure For Checking Fluid Level
To properly check the automatic transaxle fluid level, the
following procedure must be used:
• The vehicle must be on level ground.
• The engine should be running at curb idle speed for a
minimum of 60 seconds.
• Fully apply parking brake.
• Place the gear selector momentarily in each gear
position ending with the lever in P (PARK).
• Wipe the dipstick clean and reinsert until seated.
Remove dipstick and note reading.
• If the fluid is hot (180° F / 82° C), the reading should be
in the cross hatched area marked ”HOT” (between the
upper two holes in the dipstick).
• If the fluid is cold (80° F / 27° C), the reading should be
in the cross hatched area marked “COLD” (between
the lower two holes in the dipstick).
• If the fluid level shows low, add sufficient transmis-
sion fluid to bring to the proper level.
222 MAINTAINING YOUR VEHICLE