Chrysler 2005 Sebring Coupe - Manual (Page 25)

CAUTION!
Do not make any alterations or additions to the
sentry key system. Any alterations or additions
could cause failure of the sentry key.
Replacement keys
NOTE :
Only keys that have been programmed to the vehicle
electronics can be used to start the vehicle.
If you lose the key, you can order a key from your
authorized dealer by referring to the key number.
You will also need to register the key ID code.
Your dealer can register the key ID’s or you can follow
the
ЉCustomer Key ProgrammingЉ procedure.
You are provided with 2 keys, but you may add up to 6
more keys, for a total of 8 registered to the vehicle.
Customer Key Programming
You can program new keys to the system if you have two
valid keys by doing the following:
NOTE :
A valid key is one that will start and run the vehicle.
1. Insert the first valid key into the ignition and turn the
ignition to the
ЉONЉ position for 5 seconds.
2. Turn the ignition to the ЉOFFЉ position and remove the
first key.
3. Insert the second valid key and switch the ignition in
the
ЉONЉ position within 7 seconds.
Theft-alarm indicator will blink twice.
Turn the ignition to the
ЉOFFЉ position and remove the
second key.
4. Insert a blank Sentry Key into the ignition and switch
the ignition in the
ЉONЉ position within 7 seconds.
The theft-alarm indicator will illuminate for about 3
seconds when the registration is completed.
LOCKING AND UNLOCKING 25
2