Beltalert programming, Beltalert programming – Chrysler 2009 Sebring Sedan - Owner Manual User Manual
Page 53
![background image](/manuals/671720/53/background.png)
warning is triggered, BeltAlert
will continue to chime
and flash the Seat Belt Warning Light for 96 seconds or
until the driver’s seat belt is buckled.
BeltAlert
will be reactivated if the driver’s seat belt is
unbuckled for more than 10 seconds and the vehicle
speed is greater than 5 mph (8 km/h).
BeltAlert
ா
Programming
BeltAlert
can be enabled or disabled by your authorized
dealer or by following these steps:
NOTE:
• The following steps must occur within the first 60 sec-
onds of the ignition switch being turned to the ON or
START position.
• Chrysler LLC does not recommend deactivating
BeltAlert
.
1. Turn the ignition switch to the LOCK position and
buckle the driver’s seat belt.
2. Turn the ignition switch to the ON position and wait
for the Seat Belt Warning Light to turn off.
3. Within 60 seconds of turning the ignition switch to the
ON position, unbuckle and then re-buckle the driver’s
seat belt at least three times within 10 seconds, ending
with the seat belt buckled.
NOTE:
Watch for the Seat Belt Warning Light to turn on
while unbuckling and off while re-buckling the seat belt.
It may be necessary to retract the seat belt partially each
time when unbuckling.
4. Turn the ignition switch to the LOCK position. A
single chime will sound to signify that you have success-
fully completed the programming.
BeltAlert
can be reactivated by repeating this procedure.
NOTE:
Although BeltAlert
has been deactivated, the
Seat Belt Warning Light will continue to illuminate while
the driver’s seat belt remains unbuckled.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
51
2