Jacking instructions, What to do in emergencies – Chrysler 2010 PT Cruiser - User Guide User Manual

Page 34

Advertising
background image

• Block both the front and rear of the wheel

diagonally opposite the jacking position.
For example, if changing the right front
tire, block the left rear wheel.

NOTE: Passengers should not remain in the
vehicle while the vehicle is being jacked.

Jacking Instructions

WARNING!

Carefully follow these tire changing warnings to help prevent personal injury or
damage to your vehicle:

• Always park on a firm, level surface as far from the edge of the roadway as

possible before raising the vehicle.

• Block the wheel diagonally opposite the wheel to be raised.

• Set the parking brake firmly, and shift the transmission into PARK.

• Never start or run the engine with the vehicle on a jack.

• Do not let anyone sit in the vehicle when it is on a jack.

• Do not get under the vehicle when it is on a jack.

• Only use the jack in the positions indicated and for lifting this vehicle during a

tire change.

• If working on or near a roadway, be extremely careful of motor traffic.

• To assure that spare tires, flat or inflated, are securely stowed, spares must be

stowed with the valve stem facing the ground.

• Turn on the Hazard Warning flasher.

• Remove the scissors jack and lug wrench from the stowage bag.

NOTE: If equipped with a center cap that covers the wheel nuts, pry off the cap
using the small end of the lug wrench. To reinstall the cap, make sure it is properly
lined up before pushing it onto the wheel.

Loosen, but do not remove, the wheel nuts by turning them to the left one turn while
the wheel is still on the ground.

WHAT TO DO IN EMERGENCIES

32

Advertising