Chrysler 2011 200 Convertible - Owner Manual - Manual (Page 56)

Enhanced Seat Belt Use Reminder System
(BeltAlert
ா)
BeltAlert
௡ is a feature intended to remind the driver to
fasten their seatbelt. This feature is active whenever the
ignition is on. If the driver is unbelted, the Seat Belt
Reminder Light will turn on and remain on until the
driver seatbelt is fastened.
The BeltAlert ௡ warning sequence begins within 60 sec-
onds of the vehicle speed over 5 mph (8 km/h), by
blinking the Seat Belt Reminder Light and sounding an
intermittent chime. Once the sequence starts, it will
continue for 96 seconds or until the driver seatbelt is
fastened. After the sequence completes, the Seatbelt
Reminder Light remains illuminated until the driver
seatbelt is fastened. The driver should instruct all other
occupants to fasten their seatbelts. If the driver seatbelt is
unbuckled while traveling at speeds greater than 5 mph
(8 km/h), BeltAlert
௡ will chime once and illuminate the
Seat Belt Reminder Light, then will proceed to the
96 second warning sequence.
BeltAlert
ா Programming
NOTE: Chrysler Group LLC does not recommend de-
activating BeltAlert ௡.
BeltAlert ௡ can be enabled or disabled by your authorized
dealer or by performing the following steps:
NOTE: The following steps must occur within the first
60 seconds of the ignition switch being turned to the
ON/RUN position. Chrysler Group LLC does not recom-
mend deactivating BeltAlert
௡.
1. With the ignition in the OFF position, buckle the
driver’s seat belt.
54 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE