CLEAR PC Card - Manual (Page 5)

1 Installing and using Clearwire pc card 2
Installing the Clearwire pc card driver
Do not insert your pc card until after you install the software
Before using the Clearwire pc card for the first time, you must install the software included with your card.
1 Insert the installation CD or USB drive into laptop PC.
The installation program automatically runs.
If the installation program does not automatically run:
• From the Start menu, select Run .
• When the Run dialog box opens, type X:\ Setup where X: is your laptop PC’s CD-ROM or USB drives.
• Click OK .
2 Follow the on screen instructions to complete the installation.
Plugging in the Clearwire pc card
Do not insert your pc card until after you install the software
1 After powering on your laptop, slide the pc card into the slot on your laptop.
2 The pc card detects the network.
You can discover the connection status of your pc card in the following ways:
• The icons displayed in your laptop’s system tray vary depending on the operating state
of the pc card and the signal strength it detects.
*
or
Lap top card softw are
Cop yrig ht © 200 7 Clea rwire Corpo ration. All Rights Reserved
©20 07
e served es
learw ireCo rpo
Cl lea 200 7Cl i eCo rporat ion.All Rights g ts hts hts Re Res
ea Cl
Figure 1.5 Insert the installation CD or USB drive into laptop PC
Figure 2 Plugging pc card into laptop computer
Figure 3 System tray icons: connected/signal strength icons
*