Cub Cadet 190-002 - Manual (Page 14)

14
SECTION 8: KNOW THE TILLER
Figure 14
Lift Switch
The lift switch is located on the right side of the steering
wheel on the dash panel and is used to raise and lower
the tiller attachment and also to determine the depth at
which the tines dig into the ground. See Figure 15.
Figure 15
Pushing forward, or up, on the switch will raise the tiller.
Pulling down, or back, on the switch will lower the tiller.
The electric lifting cylinder will produce a clicking noise
when it reaches its maximum lift or lowered height.
When this noise is heard, immediately release the
switch to prevent damage to the electric lift cylinder.
Tine Direction Lever
The tine direction lever is located on the top of the tiller
attachment on the right side of the unit. Refer to Figure
14. This lever is used to control which direction the tines
turn.
Figure 16
The lever has three positions. F is the forward tilling
position. By pulling the tine direction lever toward the
front of the tractor (refer to Figure 16), this will activate
the tines into forward tilling motion. Forward tilling is
used when cultivating or tilling soft soil.
N is the neutral position. When the lever is in this
position, the tiller tines are not in motion. The N position
is located between the forward and reverse positions
on the lever. Neutral is used whenever transporting the
unit.