Comfort Company Swing-Clear Lap Tray - Manual

SWING CLEAR LAP TRAY
Toll Free 800.564.9248
www.comfortcompany.com
509 South 22nd Ave Bozeman, MT 59718
IS-SWINGCLEARTRAY
REV0413
1
2
5
Remove existing armrest from wheelchair.
Remove two screws (A) from bottom clamp
(B). Set the top half of the clamp (C) to the
top of the wheelchair arm rail. Then reinstall
the bottom clamp (B) using the screws (A).
3
Adjustment lever (D) should always be
screwed in far enough to securely hold the
assembly together. To adjust, loosen the
lever (D), shift the tray to the desired posi-
tion, then tighten the lever once again to lock
the tray into position.
4
Insert the shoulder bolt (A) into the washer
(B), mounting bracket (F) and thread securely
into the interlock cane clamp (C).
Attach the interlock cane clamp to the leg
rest wheelchair tube. For 1” diameter tubes,
use the longer socket head cap screws
provided in the products kit bag.
6
Attach the mounting bracket (F) to the foam
pad assembly (G) using two of the pan head
screws (E). The third screw is provided for
aesthetic purposes.
7
Insert the shoulder bolt (A) into the washer
(B), mounting bracket (F) and thread securely
into the interlock cane clamp (C).
8
Attach the interlock cane clamp to the leg
rest wheelchair tube. For 1” diameter tubes,
use the longer socket head cap screws
provided in the products kit bag.
9
Attach the mounting bracket (F) to the foam
pad assembly (G) using two of the pan head
screws (E). The third screw is provided for
aesthetic purposes.
Parts Included:
1 - Swing Clear Lap Tray Assembly
2 - 3/16” Allen Wrench
A
B
C
D
*NOTE: The various holes on the mounting bracket
(F) allow for varying foam height mounting.
*NOTE: The provided diagram shows the assembly
instructions for the left side leg rest.
*NOTE: The various holes on the mounting bracket
(F) allow for varying foam height mounting.
*NOTE: The provided diagram shows the assembly
instructions for the left side leg rest.