Comtrol SICK LMS - Manual (Page 11)

Installing the DeviceMaster 500 and the SICK LMS Scanner (Windows): 2000472 Rev. C 11
Software Installation
12. Connect the power cord of the scanner to a power source. When the scanner
displays a green light, you should see a message on the WCom2 window.
13. Use the Port/Send ASCII / HEX String menu to send the appropriate hex
commands using LMS scanner manual to perform these steps:
a. Send a request to the scanner to start measuring.
b. Send a request to the scanner to stop measuring.
c. Send a request to the scanner to set the baud rate to 500K.
d. After you get the
confirmation, change the
COM port setting in
WCOM2 to 500K by using
the Settings/Port Settings
menu.
e. Repeat Steps a and b to
make sure that the
scanner is working at
500K.
Note: You can use this step for
any baud rate.