Comtrol ES7510-XT - Manual (Page 150)

150 - Port Configuration (CLI) RocketLinx ES7510-XT User Guide: 2000571 Rev. D
Configuration Using the Command Line Interface (CLI)
Port Configuration (CLI)
The Port Configuration group allows you to enable/disable port state, or configure port auto-negotiation,
speed, duplex, flow control, rate limit control, and port aggregation settings. It also allows you to view port
status and aggregation information.
Optionally, you can use the web user interface for configuration, see Port Configuration on Page 67.
This table provides detailed information about the CLI commands for port configuration.
Port Control
Port Control
– State
Switch(config-if)# shutdown -> Disable port state
Port1 Link Change to DOWN
interface fastethernet1 is shutdown now.
Switch(config-if)# no shutdown -> Enable port state
Port1 Link Change to DOWN
Port1 Link Change to UP
interface fastethernet1 is up now.
Switch(config-if)# Port1 Link Change to UP
Switch(config)# sfp
ddm Digital diagnostic and monitoring
eject Eject SFP
scan Scan SFP
Switch(config)# sfp ddm
enable Enable DDM
disable Disable DDM
Port Control
– Auto
Negotiation Switch(config)# interface fa1
Switch(config-if)# auto-negotiation
Auto-negotiation of port 1 is enabled!
Port Control
– Force
Speed/
Duplex
Switch(config-if)# speed 100
Port1 Link Change to DOWN
set the speed mode ok!
Switch(config-if)# Port1 Link Change to UP
Switch(config-if)# duplex full
set the duplex mode ok!