Comtrol DM ATS-XPe - Manual (Page 89)

Appendix D. Changing BIOS Configuration 89
SVGA Setup Introduction
SVGA Setup Introduction
The DeviceMaster ATS-XPE is equipped with an on-board LCD/VGA interface.
The following subsections discuss its specifications and features.
Chipset
The DeviceMaster ATS-XPE uses a Cyrix
™
CX5530 chipset as its SVGA
controller. The chipset is compatible with most traditional analog CRT monitors
and also accepts most interlaced and non-interlaced analog monitors (color and
monochrome VGA) with high-resolution quality while maintaining complete
IBM
™
VGA compatibility.
Digital monitors (i.e. MDA, CGA, and EGA) cannot be supported. Multiple
frequency (multisync) monitors operate as if they are analog monitors.
Display Memory
With the 4 MB UMA memory, the VGA controller can make CRT displays or color
panel displays perform with resolutions up to 1024 x 768 at 64K colors.
Display Driver
A standard VGA driver is loaded.
PCI Bus Ethernet Interface
The DeviceMaster ATS-XPE provides a high performance 32-bit Ethernet chipset
which is fully compliant with the IEEE 802.3 standard. The Ethernet port
supports a standard RJ45 connector and is both 100Base-T and 10Base-T
compatible. The major network operating system fits it. The Ethernet port
supplies a standard RJ45 connector on board.