Comtrol RocketPort Serial Hub Series - Manual (Page 30)

30 Using VS-Link
Windows NT
Using VS-Link
Use the following subsections if you need to:
• Change any configuration parameters, see Changing
Configuration Parameters on Page 33:
- Name of the unit
- Number of ports
- Starting COM port number
- Backup server usage
• Configure the Backup server feature, see Configuring the Backup
Server Feature on Page 34
• Add additional hardware units, see Adding Units After the Initial
Installation on Page 35
• Use the hot swap feature, see “Hot-Swapping” Units on Page 36
• Use optional VS-Link features, see Using Optional VS-Link
Features on Page 37:
- Enabling Verbose mode for Event logging
- Setting scan rates
- Toggling RS-232 port usage to RS-485 using an external
convertor box
• Configure port specific features, see Configuring Specific Port
Features on Page 40:
- Lock baud rates to access higher or lower rates than are
normally permitted by your Windows NT applications
- Set a timeout time on transmit data on a port
- Map CD to DSR
- Map 2 stop bits to 1
- Wait for physical transmission before write
- Close port settings
- Reset port settings to the default condition