Comtrol NS-link Windows NT - Manual (Page 9)

Overview 9
Device Preparation for NS-Link
Device Preparation for NS-Link
Use the appropriate table to verify that your hardware was installed properly and
is ready for NS-Link installation. See the hardware installation documentation
(Page 6) if you need to install the hardware.
• DeviceMaster Serial Hub LEDs (below)
• DeviceMaster RTS LEDs on Page 10
• DeviceMaster PRO LEDs on Page 11
• RocketPort Serial Hub ia LEDs on Page 11
• RocketPort Serial Hub Si LEDs on Page 11
DeviceMaster Serial
Hub LEDs Use this table to verify that your DeviceMaster Serial Hub is ready for NS-Link
installation.
Model
How to tell if the DeviceMaster Serial Hub is working
properly:
DeviceMaster
Serial Hub 8
• The PWR LED on the front of the unit is lit, which indicates
it has power and has completed the boot cycle.
Note: The PWR LED flashes while booting and it takes
approximately 15 seconds for the bootloader to
complete the cycle.
• The red LNK/ACT LED is lit, which indicates a working
Ethernet connection.
• If the red 100 LED is lit, it indicates a working 100 MB
Ethernet connection (100 MB network, only).
DeviceMaster
Serial Hub 16
• The Status LED on the front of the unit is lit, which indicates
it has power and has completed the boot cycle.
Note: The Status LED flashes while booting and it takes
approximately 15 seconds for the bootloader to
complete the cycle.
• The red LNK/ACT LED is lit, which indicates a working
Ethernet connection.
• If the red Duplex LED is lit, it indicates full-duplex activity.
• If the red 100 LED is lit, it indicates a working 100 MB
Ethernet connection (100 MB network, only).