DLE 85 - Manual (Page 7)

7
Ignition Wire
(To Spark Plug)
Ignition Control Switch Wire (To On/Off Switch)
Pick-Up
Sensor Wire
(To Sensor
On Engine)
Tachometer Lead/
RPM Signal Output
ELECTRONIC IGNITION
SYSTEM
Battery Lead
Charge Lead
Switch (Not included)
Tachometer
(Not included) DLEG5525
OPTO Gas Engine Kill Switch
(DLEG9205, not included)
OPTIONAL
Ignition
Battery Lead
Ignition
Rx Batt
Lead
Rx
LED
KILL
SWITCH
Installing the DLE-85 on Your Airplane
Note: The DLE-85 must be installed on at least a 9.5mm [3/8"]
thick 5-ply plywood fi rewall. The fi rewall must be securely glued to
the airplane. Use triangle stock and pin the fi rewall with hardwood
dowels to reinforce the fi rewall glue joints. Never install the
DLE-85 onto a fi rewall thinner than specifi ed because it may fail
due to the power of the engine.
Note: The length of the engine from the back of the engine mount
to the propeller drive washer is 7.87" [200 mm].
1. Use the supplied template (on the back cover of this manual) to
drill the engine mounting bolt holes.
2. Install (4) 5mm blind nuts on
the back side (non-engine side of
the fi rewall) in the holes drilled in
step 1.
3. Install the 8 grommets and
4 spacers to the anitvibration
mount as shown.
4. Install the 4 standoffs to the
engine in the orientation shown
using the (4) 5x20mm SHCS and
5mm washers. Be sure to use
threadlocker.