DLE 222 - Manual (Page 7)

7
between the modules and the mounting surfaces and that Velcro ®
is used to hold the modules in place.
10. Secure all connections with heat shrink tubing (not included).
Ignition Wires
to rear cylinders
Ignition Wires
to front cylinders
Ignition Control Switch Wire
(To On/Off Switch)
Pick-Up
Sensor Wire
(To Sensor On Engine)
Tachometer
Lead/
RPM
Signal
Out-Put
ELECTRONIC
IGNITION SYSTEM
Battery Lead
Charge Lead
Switch
(2 Required - not included)
Ignition Control Switch Wire
(To On/Off Switch)
Battery Lead
Charge Lead
Switch
(2 Required - not included)
Optional
Tachometer
(Not included)
Pick-Up
Sensor Wire
(To Sensor On Engine)
Tachometer
Lead/
RPM
Signal
Out-Put
ELECTRONIC
IGNITION SYSTEM
The Ignition Pick-Up Sensor Wire labeled in this picture of the
engine corresponds to the rear cylinders. Connect the Ignition
Pick-Up Sensor Wire to the EIS that will control the ignition of the
spark plugs installed in the rear cylinders.
The Ignition Pick-Up Sensor Wire labeled in this picture of the
engine corresponds to the front cylinders. Connect the Ignition
Pick-Up Sensor Wire to the EIS that will control the ignition of the
spark plugs installed in the front cylinders.