Sealing a tire with tirefit – Dodge 2011 Challenger SRT8 User Manual

Page 339

Advertising
background image

WARNING! (Continued)

TIREFIT Sealant solution contains latex. In case of

an allergic reaction or rash, consult a physician
immediately. Keep TIREFIT out of reach of chil-
dren. If swallowed, rinse mouth immediately with
plenty of water and drink plenty of water. Do not
induce vomiting! Consult a physician immediately.

Sealing A Tire With TIREFIT

(A) Whenever You Stop To Use TIREFIT:

1. Pull over to a safe location and turn on the vehicle’s
Hazard Warning flashers.

2. Verify that the valve stem (on the wheel with the
deflated tire) is in a position that is near to the ground.
This will allow the TIREFIT Hoses (6) and (7) to reach the
valve stem and keep the TIREFIT kit flat on the ground.
This will provide the best positioning of the kit when

injecting the sealant into the deflated tire and running the
air pump. Move the vehicle as necessary to place the
valve stem in this position before proceeding.

3. Place the transmission in PARK (auto transmission) or
in Gear (manual transmission) and turn Off the ignition.

4. Set the parking brake.

(B) Setting Up To Use TIREFIT:

1. Turn the Mode Select Knob (5) to the Sealant Mode
position.

2. Uncoil the Sealant Hose (6) and then remove the cap
from the fitting at the end of the hose.

3. Place the TIREFIT kit flat on the ground next to the
deflated tire.

4. Remove the cap from the valve stem and then screw
the fitting at the end of the Sealant Hose (6) onto the
valve stem.

6

WHAT TO DO IN EMERGENCIES

337

Advertising