Dodge 2010 Ram - Manual (Page 139)

and the system is disabled, the EVIC will display the
“PARK ASSIST DISABLED” message for as long as the
vehicle is in REVERSE.
The switch LED will be ON when ParkSense
௡ is disabled
or defective. The switch LED will be OFF when Park-
Sense
௡ is enabled.
Service ParkSense ா
When the ParkSense
௡ Rear Park Assist system is mal-
functioning, the instrument cluster will actuate a single
chime, once per ignition cycle, and it will display the
“CLEAN PARK ASSIST SENSORS” message. Refer to
“Electronic Vehicle Information Center (EVIC)” in “Un-
derstanding Your Instrument Panel” for further informa-
tion. When the shift lever is moved to REVERSE and the
system has detected a faulted condition, the EVIC will
display the “CLEAN PARK ASSIST SENSORS” message
for as long as the vehicle is in REVERSE. Under this
condition ParkSense
௡ will not operate.
If “CLEAN PARK ASSIST SENSORS” appears in the
Electronic Vehicle Information Center (EVIC) after mak-
ing sure the rear bumper is clean and free of snow, ice,
mud, or other debris, see your authorized dealer.
Cleaning ParkSense
ா
Clean the ParkSense ௡ sensors with water, car wash soap
and a soft cloth. Do not use rough or hard cloths. Do not
scratch or poke the sensors. Otherwise, you could dam-
age the sensors.
ParkSense ா System Usage and Precautions
NOTE:
• Ensure that the rear bumper is free of dirt and debris
to keep the ParkSense ௡ Rear Park Assist system oper-
ating properly.
• Jackhammers, large trucks, and other vibrations could
affect the performance of the ParkSense
௡ Rear Park
Assist system.
138 UNDERSTANDING THE FEATURES OF YOUR VEHICLE