DVIGear DVI-3221a - Manual (Page 7)

-- 5 --
6.0 CONTROLLING THE SCALER
The Scaler is controlled via three buttons and status is indicated by OSD.
• Menu Button: This Button displays the Menu Options via the On Screen Display on
the display device connected to the output. 6.1 thru 6.7 detail the sub-menus.
• + and - Buttons: These Buttons allow navigation within the Menu and adjustments
of the parameters available.
• XGA Reset: Simultaneously depressing the – and + buttons returns settings to
factory defaults and sets the output to XGA.
• 480p Reset: Simultaneously depressing the MENU and - buttons returns settings to
factory defaults and sets the output to 480p
6.1 Input Setup
When this is selected, a sub-menu of clock and phase adjustments will appear:
Clock 32/64
Phase 22/32
Use + and – Buttons to choose the parameter you want to adjust and then press the Menu
(Enter) to highlight your selection. Once a parameter is highlighted, use + and - Buttons to
increase or decrease the value of the setting. Press Menu again to leave the setting.
Move the arrow to Exit, then press Menu/Enter to Exit.
6.2 Output Setup
When this is selected, the following Output Resolution sub-menu will appear:
PC Resolution HDTV Resolution
SXGA 1280x768@60/75Hz 720p-RGB 1280x720@60Hz
1280A 1280x960@60Hz 576p-RGB 720x576@60Hz
XGA 1024x768@60/70/75/85Hz 480p-RGB 720x480@60Hz
WXGA 1280x768@60Hz 1080i-RGB 1920x1080@60Hz
SVGA 800x600@60/72/75/85Hz 720p-YPbPr 1280x720@60Hz
VGA 640x480@60/72/75/85Hz 576p-YPbPr 720x576@60Hz
VGA70 720x400@70Hz 480p-YPbPr 720x480@60Hz
VESA85 640x400@85Hz 1080i-YPbPr 1920x1080@60Hz
1152x864@70/75Hz (Pseudo Interlace - See Note 1 on Page 2)