English 16, Basic operations – Clarion DXZ585USB User Manual

Page 16

Advertising
background image

Basic Operations

English

16

DXZ585USB

● Adjusting the treble

The treble gain and treble FREQ (center
frequency) can be adjusted as follows.

The adjustment can only be performed when the
DZE is set to “DZE OFF”.

2-1. Select “TREBLE”.

2-2. Press the [

] button.

2-3. Push the [SEEK PANEL] leftward or

rightward and select from:
“T GAIN” ↔ “T FREQ”

3-1. Press the [UP] or [DN] button to adjust the

gain and FREQ (center frequency).

T GAIN

: –6 to +6 (The factory default

setting is “0”)

T FREQ

: 8KHz/12KHz (The factory default

setting is “12K”)

3-2. Press the [

] button to return to the

previous mode.

● Adjusting the sound restorer

The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.

2-1. Select “S RESTOR”.

3-1. Press the [UP] or [DN] button to adjust.

Each time you press the [UP] or [DN]
button, the sound restorer changes in the
following order:

“OFF” ↔ “1” ↔ “2” ↔ “3”

∗

The factory default setting is “OFF”.

Set this adjustment in accordance with the
music source used.

OFF:

For music sources compressed at

high bit rate

1:

For music sources compressed for high

quality at low bit rate

2:

For music sources compressed for

standard quality at low bit rate

3:

For music sources compressed for low

quality at low bit rate

● Setting high pass filter

2-1. Select “HPF”.

3-1. Press the [UP] or [DN] button to select the

setting. Each time you press the [UP] or
[DN] button, the setting changes in the
following order:

“THROUGH” ↔ “50Hz” ↔ “80Hz” ↔
“120Hz”

∗

The factory default setting is “THROUGH”
(through).

● Setting low pass filter

2-1. Select “S-W LPF”.

3-1. Press the [UP] or [DN] button to select the

setting.

Each time you press the [UP] or [DN]
button, the setting changes in the following
order:

“THROUGH” ↔ “50Hz” ↔ “80Hz” ↔
“120Hz”

∗

The factory default setting is “THROUGH”
(through).

● Adjusting the balance

2-1. Select “BALANCE”.

3-1. Press the [UP] button to emphasize the

sound from the right speaker, press the
[DN] button to emphasize the sound from
the left speaker.

∗

The factory default setting is “CENTER”.
(Adjustment range: L12 to R12)

● Adjusting the fader

2-1. Select “FADER”.

3-1. Press the [UP] button to emphasize the

sound from the front speaker, press the
[DN] button to emphasize the sound from
the rear speaker.

∗

The factory default setting is “CENTER”.
(Adjustment range: R12 to F12)

Advertising