Mounting bracket assembly, Step 1, Step 2 – Craftsman 486.24586 User Manual

Page 6: This assembly is for 917 tractor models only

Advertising
background image

6

Call 1-866-576-8388 for missing parts or assembly help

DO NOT RETURN TO STORE

FIGURE 2

LIFT LEVER

ASSEMBLY

SLEEVE HITCH

FRAME ASSEMBLY

WELD

PIN

5/8" NYLOCK NUT

SPACER PLATE

(SEE NOTE)

HEX BOLT

5/8" x 1-3/4"

STEP 1:

(SEE FIGURE 2)

•

Hook the Sleeve Hitch Frame assembly onto the weld
pins. Attach the bottom of the assembly to the tractor
hitch using a 5/8" x 1-3/4" hex bolt and a 5/8" nylock
nut.

NOte: If your tractor hitch has ridges that prevent the
sleeve hitch assembly from resting flat, place the spacer
plate underneath the sleeve hitch assembly.

SteP 2:

(SEE FIGURE 2)

•

Proceed to LIFT ASSEMBLY instructions on page 8.

MOUNTING BRACKET ASSEMBLY

FIGURE 1A

3/8" HEX NUT

3/8" LOCK WASHER

LEFT MOUNTING BRACKET

3/8" x 1-1/4"
HEX BOLT

RIGHT MOUNTING BRACKET

IF YOUR TRACTOR LOOKS LIKE FIGURE 1A
•

Install two 3/8" x 1-1/4" hex bolts in the left side of the
tractor as shown. Attach the Left Mounting Bracket
(pin at top facing in) to the bolts using two 3/8" lock
washers and 3/8" hex nuts. Repeat on the right side.

FIGURE 1B

ORIGINAL NUT

LEFT MOUNTING
BRACKET

3/8" FLAT WASHER
(TOP HOLE ONLY)

REMOVE NUTS
FROM BOLTS

RIGHT MOUNTING
BRACKET

3/8" LOCK WASHER
(If new bolt and nut are needed)

IF YOUR TRACTOR LOOKS LIKE FIGURE 1B
•

Remove the nuts from the two bolts shown in each
side of the tractor, leaving the bolts in place.

•

Attach the Left Mounting Bracket (pin at top facing
in) to the bolts using the original nuts and a 3/8" flat
washer. Repeat for the other side.

NOte: If no bolt and nut are present in a hole, use a
3/8" x 1-1/4" hex bolt, 3/8" lock washer and 3/8" hex nut to
attach the Mounting Bracket to the hole.

THIS ASSEMBLY IS FOR 917 TRACTOR MODELS ONLY.

Advertising