EDCO CPM-10 - Manual (Page 5)

E-CPL8-CPM-4-8-10-I-0112
Printed in USA
TVW
©2012
Page 5
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
1. Cutter Head Lever
2. Depth Control Knob
3. Emergency Stop Tether (CPM-10)
Stop button on (CPM-4 & CPM-8) *
4. Cushioned Handles
5. Ignition Switch (Position will vary) *
6. Throttle Control *
7. Water Hook Up
8. Fuel Tank *
9. Emergency Stop Switch Lanyard
(CPM-10) *
10. Easy Lift Handle
11. Fuel Lockoff Solenoid Toggle
For Propane Models Only.
(Not Shown) *
Figure 2
4 4
2
9
1
10
8
3 6
5
7
NOTE: Controls are similar on all models.
5
* Not on Electric models
Operating Instructions
For Gasoline or Propane Models:
Poisonous exhaust gas. Do not operate gasoline or propane powered equipment without adequate
ventilation. Carbon monoxide is an invisible, odorless gas that can kill. NEVER REFUEL A HOT
ENGINE OR AN ENGINE WHILE IT IS RUNNING. Only refuel a cool “stopped” engine in a well
ventiated area. Properly clean any spilled fuel before starting the engine.
Safety warnings and guidelines do not by themselves eliminate danger.
They are not given as substitutes for proper accident prevention and good judgement.