EDCO TILE SHARK - Manual (Page 6)

100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Printed in USA
©2013
EDCO
Page 6
E-TILESHARK-I-0913
Cutting:
• The TileShark is equipped with a 2 position handle bracket. Rear slot for normal
removal. Front slot for aggressive removal.
Concrete Base:
• Generally, on concrete based floors, the bevel on blade should be facing up
and at a fairly steep angle . (Figure 4 - angle exaggerated) If the blade “jumps up” from
the floor surface, the angle may be too shallow.
• If removing tile from a concrete base, work diagonally on the tile surface.
• Use only 2/3rds width of blade on each pass. Removing an excessive amount of
material will damage the equipment.
Wood Base:
• Generally, on wooden based floors, the bevel on the blade should be facing down and
use a flatter angle of cut. (Figure 5 - angle exaggerated) Using an angle that is too steep
may result in damage to the floor base material.
• Remove material in the direction of the wood grain to minimize gouging.
NOTE: Some gouging is unavoidable and will occur.
• Use only 2/3rds width of blade on each pass. Removing an excessive amount of
material will damage the equipment.
Starting the Machine:
•
Make sure the machine is clear of walls and/or obstructions, tilt it back slightly to shift the
weight onto the wheels, then turn the switch to ON. (Figure 3)
• Do not force the machine.
•
Shut the machine OFF when repositioning for another pass.
• Unplug machine from power source. Use the appropriate tools & techniques
to remove the blade to minimize the chance of the wrench slipping. Tilt ma-
chine back on handle to access hardware on bottom of striker plate (Figure 6).
• Loosen but do not remove the three bolts shown in (Figure 6) from the bottom
side of the striker plate.
• Inspect the new EDCO blade.
• Carefully slide the old blade out and replace with the new EDCO blade or
rotate blade if changing surfaces. Tighten bolts.
• Be sure the blade is secure before plugging the Tile Shark back in to the
power source.
Changing or Rotating the Blade:
Figure 4
Figure 5
Blades are extremely sharp! For your own protection - wear heavy duty work
gloves when changing the blades.
Figure 3
Figure 6