Emerson Radio CKD9918 - Manual (Page 10)

Press and hold the or buttons on the top panel to start stations
searches. When a station is received it will stop searching. Repeat the
procedure until your desired stations are selected.
If you tune to an FM stereo station, the ST (STEREO) indicator will light.
Rotate the VOLUME control on the left side panel to adjust the volume level.
When you are finished listening press the POWER/ALARM OFF button to
turn the unit ‘Off’. The POWER LED indicator turns off.
9
Setting the Time
AM
Press the POWER/ALARM OFF button to turn off
the unit, press once the CLK SET button and then
press either the
or buttons to adjust the hour
time forward or backward as desired. Press again
the CLK SET button and then either the
or
buttons to adjust the minute time forward or
backward as desired.
Dimmer Control
If you find the display to be too bright for sleeping, slide the DIMMER selector
switch to the LOW position. The display DIMMER selector switch is located on
the left of the side cabinet.
Listening To the Radio
Press the POWER/ALARM OFF button on the
top panel to turn the unit ‘On’. The POWER LED
indicator will light.
Press the FUNCTION button repeatedly, it will
change on the function to FM radio, AM radio, CD
and Aux. To select FM Radio, press the
FUNCTION button repeatedly until the display
shows "r-F" (FM Radio), and then MHz will
appear on the display. To select AM radio, press
the FUNCTION button repeatedly until the
display shows "r-A" (AM radio), and then KHz will
now appear on the display.
1.)
2.)
3.)
4.)
5.)
In Radio listening mode, the radio frequency display will appear for approx. 3
seconds, then the clock time will appear on the display. Press the DISPLAY
button to show the radio frequency, a few seconds later the display will show the
clock time.
MHz
FM BAND
KHz
AM BAND
MHz
ST
AM
MHz
ST
AM