Operation, First steps, The grid – EVE audio SC307 - User manual User Manual

Page 4: Operating modes, Powering on/off: standby mode

Advertising
background image

SC

307

SC

305

EVE

Audio product manual

The Grid

Powering on/off: Standby Mode

6

7

OPERATION

OPERATION

3.

OPERATION

3.1.

First Steps

Rückseitige Anschlüsse & DIP-Schalter

Check the package components (loudspeaker, user’s manual, power cord,

grid, rubber feet).
Check the voltage setting (see “Mains Voltage Selector”).
Check the setting of the DIP Switches (variable).
Connections: there are two input connectors on the rear side. These allow

the connection of balanced sources with XLR connectors or unbalanced

sources with RCA connectors.

Pin assignment XLR: 1 = Shield, 2 = hot (+), 3 = cold(-).

Pin assignment RCA: Center conductor = Signal, Ring = Shield.

Both analog inputs can be used simultaneously, whereby the signals are

summed.
The maximum level of the source signal should not exceed 8 dBu. If the

input is overloaded the LED ring will start blinking.

3.2.

The Grid
In order to protect the tweeter, your EVE Audio monitors are supplied with

a metal grid, which has no impact on the sound. The grid is attached to the

tweeter by means of magnetic attraction.
Be careful not to damage the folded tweeter diaphragm when placing the

grid:

Wrong grid position < > Correct grid position

Hold the grid with your fingers parallel to the front side of the monitor. The

perforated hexagon must exhibit two horizontal sides. Make sure that the

grid remains parallel to the front side.
Draw the grid close to the tweeter. The tweeter’s magnetic field will attract

and fix the grid, which can always be adjusted later if needed.

3.3.

Operating Modes

Standby Mode | Volume Mode (-10 dB) | Setting Menu (Low filter @ -2 dB)

3.4.

Powering on/off: Standby Mode
Press and hold the control three seconds in order to put the monitor in

Standby Mode. The volume will decrease gradually while the LED ring

lights up once around the Volume control. Afterwards, the LED on the right

end will light dimly and the power consumption is reduced to 1 watt.

!

To exit the Standby Mode press briefly the Volume control once again. The

level will increase gradually.

Advertising
This manual is related to the following products: