EVE audio SC408 - User manual - Manual (Page 4)

SC 408
SC 407
EVE Audio product manual
First Steps Horizontal/Vertical Orientation
6 7 OPERATION OPERATION
3. OPERATION
3.1. First Steps
Rear Connections & DIP Switches
Check the package components (loudspeaker, user‘s manual, power cord,
grille, rubber feet);
Check the voltage setting (see „Mains Voltage Selector“).
Check the setting of the DIP Switches (variable).
Connections: there are two input connectors on the rear side. These allow
the connection of balanced sources with XLR connectors or unbalanced
sources with RCA connectors.
• Pin assignment XLR: 1 = Shield, 2 = hot (+), 3 = cold(-).
• Pin assignment RCA: Center conductor = Signal, Ring = Shield.
Both analog inputs can be used simultaneously, whereby the signals are
summed.
Depending on the setting of the Max. Input DIP switch on the rear panel,
the maximum level of the source signal should not exceed +7 dBu or +22
dBu (see Max. Input). If the input is overloaded the LED ring will start
blinking.
3.2. Horizontal/Vertical Orientation
The SC407 and SC408 can be used in horizontal or vertical position thanks
to the incorporated swiveling „Mid/High Silver Plate.“ By default, your
monitor is adjusted to be placed horizontally. To use it in vertical position,
turn the tweeter/mid-driver section 90º so that the sound transducer is
vertically oriented. Your dealer will be happy to this for you. If you would
like to do it by yourself after the monitors have been installed, follow these
steps:
• Remove the four screws of the mid/high plate.
• Turn the whole tweeter/mid-driver section 90º. The direction does not
really matter. Hold the tweeter/mid-driver section by the screws when
handling it.
• Fasten the tweeter/mid-driver section again with the screws. Tighten the
screws only a bit tighter than you would by hand.
1 3
2
! The whole procedure ought to be carried out with utmost care in order not
to damage the surface of the speaker.
! To avoid damages due to metal parts ending up inside the twitter, we
recommend you to place the protection grille immediately after any
modification.