Expert Sleepers Augustus Loop v2.4.1 - Manual (Page 32)

Clear Loop
Wipes the virtual 'tape'. Because this can be a lengthy operation (especially when the max
delay time is large) you should not expect to press this button and immediately be able to
begin recording again. During the clear operation, the Clear Loop button remains lit, and
the output level meters show a decreasing level to indicate progress.
Misc
Fix Delay
Normally when you change the pitch the delay time is changed as well. E.g. if
you change the pitch an octave up, the delay time effectively halves. If you
turn on 'Fix Delay', the delay time is changed automatically as the pitch
changes, so the effective delay time remains the same as the pitch is altered.
Trigger Arm
Arms the auto-record trigger.
In this mode the plug-in will watch for an input signal, and when it detects
one it will effectively press 'Tap Rec' on your behalf.
You can adjust the trigger level using the small slider to the left of the input level meter.
The small button below and to the right of the input level meter controls the sensitivity of
the meter. When pressed, the range of the trigger level slider matches that of the meter.
Fade
The auto-fade controls allow you to
smoothly and automatically fade
the loop in and out, effectively turn-
ing the 'Effect' level control for you.
The 'Fade' button activates the fade
operation. Press to fade out; press again to fade back in.
The 'Fade Override' button quickly completes the fade operation, in either direction.
The 'Fade In' and 'Fade Out' knobs set the corresponding fade times, in seconds (up to
30s).
The indicator to the left of the 'Fade' button shows the current level of the fade envelope
(0.0 being fully faded out, 1.0 being fully faded in).