Expert Sleepers USAMO v1.0.0 - Manual (Page 10)

The Plug-in Controls
Adjust
This section contains controls which affect the generation
of the audio signal from the incoming MIDI messages.
These will in general be used to tune the operation for
particular audio interfaces. There is a list of tested audio
interfaces and recommended settings here. If your
interface is not listed, contact Expert Sleepers for
assistance, and please do report your findings so they can
be added to the list.
Level
The Level knob simply sets the output level of the plug-in. It has exactly the same effect as
adjusting the track fader in the DAW.
Space
Raising the Space knob from Off slows down the transmission of MIDI, to allow
compatibility with certain audio interfaces. It is rarely necessary.
Balance
Lowering the Balance knob from Off slows down the transmission of MIDI, to allow
compatibility with certain audio interfaces (but in a different way to the Space knob
above). It is generally only necessary when using the USAMO to transmit MIDI Sysex
messages, and even then only with certain audio interfaces.
MIDI Out
This section controls
the plug-in’s response
to MIDI, and the MIDI
messages generated by
the plug-in.
Channel
Specifies the MIDI channel to receive on. All MIDI messages from this channel are echoed
out to the USAMO’s output. “Off” disables this feature (but not the MIDI clock output, if
enabled). “Omni” receives messages on all MIDI channels.
!10