Expert Sleepers Augustus Loop v1.8.0 - Manual (Page 19)

Filter
Cutoff
Controls the filter cut-off frequency (in Hz).
Q
Controls the filter resonance.
Type
Allows you to smoothly change between the following filter types:
• Thru - no filtering
• Low - lowpass filter
• Band - bandpass filter
• High - highpass filter
LFO Speed
Controls the speed of the filter LFO (in Hz), which modulates the cutoff frequency.
LFO Depth
Controls the depth of the filter LFO. The value is a number of octaves to sweep the cutoff
frequency by.
Saturate
The button below the 'Saturation' control (where the knob’s label would normally be)
turns the saturation effect on and off. NB when this is turned off, the signal in the loop can
reach very high levels which may cause problems further down the line.
Saturation
Controls the level of saturation (overdrive) applied to the signal (before being fed into the
filter).