Fawcett EMD-100 - Manual (Page 4)

Installation
Your new disperser is supplied partially assembled.
For more information, see the parts list pages for
general arrangement drawings.
Dispersers:
To install the disperser blade, remove one of the jam
nuts. Insert the disperser blade onto the shaft.
Assemble and tighten the second jam nut firmly to
secure the disperser blade to the shaft.
Disperser Blade Placement:
Experimenting with disperser blade placement may
provide your best results.
Assembly:
STEP #1: Install the container holder, onto the bottom
of the support.Install short end (below collar) of 36”
long aluminum support rod into base and tighten set
screw in base securely using supplied allen wrench.
STEP #2: Slide motor and support clamp assembly
onto support rod until shaft collar is reached.
STEP #3: Slide dispersion shaft into the ½” chuck and
tighten with supplied key. Tighten securely so the shaft
cannot work loose.
STEP #4: If necessary, reposition motor stop collar on
support rod to correct minimum operating height.
STEP #5: Plug motor cord into variable speed
controller. DO NOT plug motor directly into wall power
outlet.
STEP #6: Making sure variable speed controller is
OFF, and speed control is set to ZERO, plug controller
into a 110 VAC wall outlet.
STEP #7: Install disperser blade on to end of the
dispersion shaft between the supplied jam nuts.
STEP #8: Verify motor support clamp has been
tightened to support bar. Unit is now ready to operate.
FAWCETT Co, Inc. LS manual 03/06 page 4 of 7