Fieldmann FZR 2020-E - Manual (Page 18)

FZR 2020-E
18 EN Storing the lawnmower | Possible problems and troubl shooting
14. STORING THE LAWNMOWER
Before storing, clean the outer surface of the lawnmower using a soft brush and cloth. Do not
use water, solvents and polishing agents. Remove any grass remains, particularly from the
vents.
Tilt the machine on the side and clean the blade mechanism. Grass remains in the blade
mechanism can be removed it using a wooden or plastic tool. Store the lawnmower in a dry
place. Do not place any objects on top of the lawnmower.
Unscrew the nut 9 and fold the upper handle 2.
When folding/unfolding the handle, make sure the power cable is not hitched on any part of
the lawnmower. When folding the handle, never let the folded part of the handle fall down.
15. POSSIBLE PROBLEMS AND TROUBL
SHOOTING
The following table shows examples of defects which could prevent trouble-free operation
of the lawnmower and methods of remedying these defects. If the problem persists, despite
the suggested measures, please contact the Customer Service.
ATTENTION! Before trouble-shooting, switch off the lawnmower and unplug the plug from
the socket.
PROBLEM POSSIBLE CAUSE SOLUTION
Lawnmower will not
start The lawnmower has not been
switched on, defective socket,
damaged extension cable,
Blown fuse, engine protection
activated, engine protection
activated Switch the lawnmower on, Use
another socket Check the cable and
replace it if necessary Replace the
fuse Increase the cutting height and
tilt the lawnmower on the side Let
it cool down and then increase the
cutting height Let the lawnmower
cool down for a few minutes and
then increase the cutting height
During this time do not operate the
switch lever 1
as this will prolong the time to
automatically
reset the safety cut-out