Fieldmann FZN 6005-E - Manual (Page 14)

FZN 6005-E
14 EN Safety instructions
Additional safety instructions
Work area safety Use power tools solely in the manner and for the purpose described in these
operating instructions. The operator or user of the tool is fully responsible for possible
accidents or potential danger to other persons or their property.
Electrical safety
To increase safety, the British Standards Institute recommends using residual current device
(RCD) protected supply with tripping current of 30mA or less when operating power tools.
Before each use of the power tool check the function of the residual current device. Before use
check the integrity of the power cord. If the cord shows signs of wear and tear or damage,
replace it.
Do not use the tool, if the cables are damaged or worn out.
If the cord is cut or its insulation is damaged, immediately de-energize the tool. Do not touch
the cable until the device is de-energized.
Keep the cable straight and untangled. Entangled cables may overheat and reduce the
performance of your tool.
Before unplugging the power cord or extension cord, always first switch off the tool using the
mains switch.
Switch off the tool, unplug the cable and before winding and storing the cable check whether
it is not excessively worn out or damaged. Do not repair damaged cable, always replace it by
a new one.
Wind the cable carefully to prevent kinking.
To power the tool, use exclusively alternating voltage power network with parameters
matching the information on the tool’s type label.
Under no circumstances connect any part of the tool to an earth wire.
Cables
Use only extension cables approved according to HD 516 standard.
Seek a technician - electrician.
Personal safety
Always wear appropriate work clothing, protective gloves and solid shoes.
Before cutting, inspect the shrubs thoroughly and remove any foreign objects and wires.
When adjusting the tool (rotating the cutting unit, tilting the cutter, etc.), fit the blade scabbard
first. During these operations the hedge trimmer may not lean against the cutting blade.
Each time before you start using the tool and after any impact which occurred during cutting
check for possible hedge trimmer wear and tear or damage and have it repaired, if necessary.
Before commencing work with the electric telescopic hedge trimmer, always make sure that
the hand protection shield is attached in the correct position.
Never use tool which is incomplete or tool which was modified in an unauthorised manner.