Fieldmann FZP 3714-B - Manual (Page 15)

EN
CHAIN SAW USER'S MANUAL
15
5. At this point, push the choke lever (Fig.7, point 3)
downwards to the "ON" position (=air supply turned
on, i.e. choke turned off) and start the engine by
repeatedly pulling on the starting cord.
ATTENTION! Spinning the engine for too long
with the choke lever in the OFF position will result in
fl ooding of the engine and problems with starting it up.
6. Prior to starting work, leave the engine to warm
up for a few minutes to get up to operating
temperature.
Starting a warm engine
1. Set the power switch (Fig. 7, point 1) to the "I"
position.
2. Pull on the handle of the starting cord until the
engine starts up (Fig. 8). DO NOT USE THE CHOKE!
ATTENTION! In the event that the fuel in the fuel
tank was completely used up, after pouring in fuel,
repeat the steps for STARTING A COLD ENGINE.
Speed control
To increase speed, fi rst use the palm of your hand to push down the throttle safety switch (Fig. 7, point 4)
and then use your fi nger to pull on the throttle trigger (Fig. 7, point 5)
To lower the speed, release the throttle trigger
Stopping the engine
Release the throttle trigger (Fig. 7, point 5) and switch the power switch (Fig. 7, point 1) to the "0" position.
WARNING
The engine exhaust fumes contain chemical substances that are damaging to health. Never inhale these
fumes. Always start the chain saw outdoors.
Checking chain lubrication
ATTENTION! Adhere to safety provisions and
prevent the guide bar from coming into contact
with the surface of the terrain.
Use this power tool safely and maintain
a minimum distance of 20 cm from the ground.
Before starting work, check the chain lubrication
and the amount of oil in the oil tank. Start the
chain saw and hold it above the ground. If you see
Fig. 7
2
3
4
5
1
Fig. 8
Fig. 9
Turning the chain saw on and off