Fieldmann FZP 2020-E - Manual (Page 18)

EN 18
FZP 2020-E
Replacing the saw chain | Storage
Loosen and remove the bar guide bolt.
Remove the sprocket cover.
Remove the saw chain.
Wind the new chain around the cogged wheel, then along the top
groove of the guide bar and around the guide bar nose.
Note: Check that the saw teeth are facing in the correct direction.
Put on the chain so that the teeth on the top side of the guide bar
are facing towards the guide bar nose (see fi gure).
Before placing the sprocket cover into position, check that the chain
tensioning pin is inserted into the adjustment hole on the guide bar.
Put the sprocket cover back on to the body of the chain saw.
Fasten the sprocket cover using the guide bar bolt.
ATTENTION!
Only tighten the bolt by hand.
Adjust the tension of the saw chain.
Tighten the guide bar bolt.
ATTENTION!
Check that you have not placed the saw chain on the guide bar in the opposite direction.
Otherwise, the chain saw will exhibit excessive vibrations and will not cut.
15. STORAGE
If you will not use the chain saw for longer than 30 days, proceed as follows.
Drain the oil tank.
Remove and clean out the guide bar and chain. Submerge the guide bar and chain into a kerosene-based or
soap cleaning solution.
Then dry the guide bar and the chain.
Put the chain into a container fi lled with oil. This will prevent it from corroding.
Gently coat the guide bar with oil.
Wipe the body of the chain saw with a cloth. When cleaning, use a soft cloth dipped in a soap solution.
Store the chain saw
• In higher shelves or in locked areas out of children’s reach
• in a dry location