Fieldmann FDK 2001-E - Manual (Page 20)

FDK 2001-E
20 EN Safety instructions
ATTENTION! Except for plunge cuts, always use the riving knife.
ATTENTION! In order for the riving knife to work, it must fit into the cut-out in the processed
piece.
ATTENTION! Do not operate the saw if the riving knife is bent.
ATTENTION! Make sure that the riving knife is so adjusted that the distance between the
riving knife and the blade rim is not greater than 5 mm and the blade rim does not reach out
behind the lower edge of the riving knife by more than 5 mm.
ATTENTION! When replacing the circular-saw blade, make sure that the cut width is not
smaller than the depth of the riving knife.
Avoid the kickback of the saw.
ATTENTION! Kickback occurs when a force is exerted against the saw blade causing a
quick and unexpected lift up of the wood. Kickback is very dangerous but can be minimised if
you identify its causes and avoid them.
The root of the circular-saw blade should always be in tight contact with the cut material
Always hold the saw with your both hands. Support the cut parts by large panels.
Be careful when cutting long parts which can be bent, twisted or pinch the circular-saw blade.
Never cut in the centre of the supported piece of wood. The wood could bend over and pinch
the circular-saw blade.
Never cut overhead.
Do not exert pressure upon the saw. Let the circular-saw blade work at its own rate.
Secure the flange using clamps or cramp to avoid vibrations and irregular cuts.
Do not let the blade leave the cutting line as it could cause the saw jump out of the kerf.
Before cutting, check the wood and remove all bolts, clamps and nails.
Replace the circular-saw blade if it is dull.
Only use circular-saw blades according to EN 847-1 and never use circular-saw blades made
of high speed steel - HSS.
ATTENTION! Wear hearing protection to reduce the risk of impaired hearing! Use protection
against dangerous dust inhaling.
ATTENTION! Wear gloves when working with circular-saw blades and roughly machined
materials - circular-saw blades should be carried in holders, if possible.
ATTENTION! Use means of protection against noise, dust and vibrations !!!
ATTENTION! Keep these safety instructions.