Fieldmann FZD 4020-E - Manual (Page 16)

FZD 4020-E
16 EN Operation | Cleaning, maintenance and ordering of spare parts
Clean the cutting surfaces of the blades, the blade plate and the ejector chute with a brush or
paintbrush. Remove pieces of wood or other parts that may prevent the blade plate from
turning.
Close the loading funnel again and tighten the safety screw.
Safety
The shredder has a safety switch (Figure 12a/ Item A) in its interior on the motor housing. The
control unit for it (Figure 13/Item F) is located on the loading funnel.
If the loading hopping is not perfectly position or if it is not pressed against the motor housing,
the SAFETY SWITCH will trip and prevent the motor from working. If this situation occurs, open the
loading funnel as described above. Carefully clean the interior. Close the loading funnel again as
described above and ensure that when you switch on the machine again the loading funnel is
correctly position and the safety screw is screwed right in.
ATTENTION! NEVER undo the release screw (Figure 1/Item 12) without first switching off
the machine at the ON/OFF switch (Figure 1/Item 11) and disconnecting the coupling on the
machine connection cable (extension) from the machine plug.
8. REPLACING THE POWER CABLE
If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to avoid danger.
9. CLEANING, MAINTENANCE AND
ORDERING OF SPARE PARTS
Always pull out the mains power plug before starting any cleaning work.
Maintenance and storage
Clean the machine regularly. This will help to keep the machine in good working order and is
the basis for a long working life.
Keep the vent slots clean while you work.
Clean the plastic body and other plastic parts with a mild household cleaning agent and a
damp cloth. Do not use any aggressive agents or solvents for cleaning purposes.
Never clean the shredder by spraying with water.
Prevent water getting inside the machine at all cost.
Check the chassis securing screws from time to time to ensure that they are tight.