FloAire Fully Integrated Self Cleaning System - Manual (Page 25)

25
Start-Up and Maintenance Documentation
START-UP AND MEASUREMENTS SHOULD BE PERFORMED AFTER THE SYSTEM HAS BEEN
INSTALLED (Warranty will be void without completion of this form)
Job Information
Job Name Service Company
Address Address
City City
State State
Zip Zip
Phone Number Phone Number
Fax Number Fax Number
Contact Contact
Purchase Date Start-Up Date
Self Cleaning Hood Information
Refer to the start-up procedure in this manual to complete this section.
Name Plate and Unit Information Field Measured Information
Hood Model Number Input Voltage
Serial Number Check All Nozzles for Tightness
Volts Open all Valves to Hood
Hertz Fill Surfactant Tank
Phase Set All Timers
Check Fan Operation
Operate Wash Cycle
Verify Surfactant Pump Operation
Verify Operating Hot Water Pressure (Table 1)
Verify Operating Cold Water Pressure (10-20 PSI)
Verify Max Water Static Pressure (125 PSI)
Verify Water Temperature
Check For Leaks in Manifold
Check For Leaks through Filters
Verify that Water is Draining Properly