Futaba 4GWD - Manual

Thank you for purchasing a Futaba 4GWD.
Before using your 4GWD, read this manual carefully and use your R/C set safely.
After reading this manual, store it in a safe place.
Application, Export, and Modification
1. This product may be used for models only. It is not intended for use in any application other than
the control of models for hobby and recreational purposes. The product is subject to regulations of
the Ministry of Radio/Telecommunications and is restricted under Japanese law to such purposes.
2. Exportation precautions:
(a) When this product is exported from the country of manufacture, its use is to be approved by the laws gov-
erning the country of destination which govern devices that emit radio frequencies. If this product is then re-
exported to other countries, it may be subject to restrictions on such export. Prior approval of the appropriate
goverment authorities may be required. If you have purchased this product from an exporter outside your
country, and not the authorized Futaba distributor in your country, please contact the seller immediately to
determine if such export regulations have been met.
(b) Use of this product with other than models may be restricted by Export and Trade Control Regulations,
and an application for export approval must be submitted. In the US, use of 72MHz (aircraft only), 75MHz
(ground models only) and 27MHz (both) frequency bands are strictly regulated by the FCC. This equipment
must not be utilized to operate equipment other than radio controlled models. Similarly, other frequencies (ex-
cept 50MHz, for HAM operators) must not be used to operate models.
 0RGL¿FDWLRQ DGMXVWPHQW DQG UHSODFHPHQW RI SDUWV  )XWDED LV QRW UHVSRQVLEOH IRU XQDXWKRUL]HG
PRGL¿FDWLRQDGMXVWPHQWDQGUHSODFHPHQWRISDUWVRQWKLVSURGXFW$Q\VXFKFKDQJHVPD\YRLGWKH
warranty.
Compliance Information Statement (for U.S.A.)
This device, trade name Futaba Corporation of America, model number R124H complies with part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause unde-
sired operation.
The responsible party of this device compliance is;
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: [email protected] (Support)
TEL (217)398-0007 or E-mail: [email protected] (Service)
Battery Recycling (for U.S.A.)
The RBRC
TM
SEAL on the (easily removable) nickel-cadmium battery contained in Fu-
taba products indicates that Futaba Corporation of America is voluntarily participating
in an industry program to collect and recycle these batteries at the end of their useful
lives, when taken out of service within the United States. The RBRC
TM program pro-
vides a convenient alternative to placing used nickel-cadmium batteries into the trash or
municipal waste system, which is illegal in some areas.
You may contact your local recycling center for information on where to return the spent battery.
Please call 1-800-8-BATTERY for information on Ni-Cd battery recycling in your area. Futaba Cor-
poration of America's involvement in this program is part of its commitment to protecting our envi-
ronment and conserving natural resources.
RBRC TM is a trademark of the Rechargeable Battery Recycling Corporation.