Philips T780/60 - Manual (Page 8)

Cleaning
I Always switch Trimmer OFF before cleaning.
I Do not use abrasive, scourers or liquids such
as alcohol, benzene, bleach or acetone to clean
the Trimmer.
• Never clean, remove or replace Guide Comb
Attachment with motor ON.
I Do not apply pressure to cutters.
I Do not touch cutters with hard objects as this
may damage them.
I Do not use while bathing, showering or
immerse the Trimmer in water or other liquids
as damage to Trimmer may occur.
I Never use sharp or hard objects to clean the
filter to avoid damaging it.
I If cut hairs have accumulated in the Guide
Comb area, turn Trimmer off. pull Guide Comb
Attachment off Trimmer and remove hairs by
shaking and/or blowing.
Hair Collection Chamber
n Switch the Trimmer OFF.
Q Open the ClearView Hair Collection
chamber cover. The cover opens from the
left side of the Trimmer to the right
side (fig. 9).
□ Remove the hairs by carefully shaking them
out or by brushing them out with the
cleaning brush supplied (fig. 10).
i When trimming extremely long, dense beards,
it may be necessary to empty the Hair
Collection Chamber during the trimming
session in order to maintain optimal suction
performance.
I If suction performance is not as strong as usual.
Hair Collection Chamber may require
emptying to restore optimal performance.
I It is recommended that the Hair Collection
Chamber be emptied and cleaned out after
each use.
I Do not operate the Trimmer with the Hair
Collection Chamber cover opened.
Trimmer
D
Make sure the Trimmer is switched OFF and
disconnected from the electrical outlet.
□ Remove the Guide Comb Attachment (fig. 7).
B Remove the cuning unit (fig. 11).
□ Clean the cutting unit and the inside of the
Trimmer with the brush supplied (fig. 12).
B Re-attach the cutting unit and the Guide
Comb into place on the Trimmer (fig. 13).