GMC 2002 Savana - Manual (Page 287)

6-20
To get the right reading, the fluid should be at
normal operating temperature, which is 180
_F
to 200
_F (82_C to 93_C).
Get the vehicle warmed up by driving about 15 miles
(24 km) when outside temperatures are above 50
_F
(10
_C). If it’s colder than 50_F (10_C), drive the
vehicle in DRIVE (D) until the engine temperature gage
moves and then remains steady for 10 minutes.
A cold fluid check can be made after the vehicle has
been sitting for eight hours or more with the engine off,
but this is used only as a reference. Let the engine run at
idle for five minutes if outside temperatures are 50
_F
(10
_C) or more. If it’s colder than 50_F (10_C), you
may have to idle the engine longer. Should the fluid
level be low during this cold check, you must check the
fluid hot before adding fluid. Checking the fluid hot will
give you a more accurate reading of the fluid level.
Checking the Fluid Level
Prepare your vehicle as follows:
D Park your vehicle on a level place. Keep the
engine running.
D With the parking brake applied, place the shift lever
in PARK (P).
D With your foot on the brake pedal, move the shift
lever through each gear range, pausing for about
three seconds in each range. Then, position the shift
lever in PARK (P).
D Let the engine run at idle for three minutes or more.