GME MT403GAUS - Manual

I N S T R U C T I O N M A N U A L
OWNER DETAIlS
Name:
Address:
Phone:
Beacon UIN/15-HEX ID:
Congratulations on purchasing your new Accusat ™ MT403 series EPIRB.
The Accusat ™ MT403 and MT403G are the most advanced 406 MHz digital
satellite beacons available today. Using new digital frequency generation
technology, GME have developed and approved world wide, a new family
of affordable high performance 406 MHz beacons.
A cAuTIONARy NOTE: The satellite EPIRB is the most signifi cant advance in
search and rescue technology in many years. It is not a substitute for a marine
radio – mariners should not be over-reliant on any single system. Wise, safe
mariners plan carefully, ensure that shore contacts know their sail plan, carry a
marine radio and the right range of other safety equipment and operate their
craft sensibly to suit conditions at sea.
GENERAl DEScRIPTION
The Accusat ™ MT403 and MT403G digital Emergency Position Indicating
Radio Beacons (EPIRB) are designed for use when the safety of your craft
and crew is endangered and you have no other means of communication.
The EPIRB can save your life and the lives of others on board by leading an
air/sea rescue to your precise location. In the past, extensive and lengthy
searches have been carried out for missing craft, sometimes to no avail.
Your GME EPIRB is a self contained 406 MHz radio transmitter that emits an
internationally-recognised distress signal on a frequency monitored by the
COSPAS-SARSAT satellite system. The MT403 and MT403G contain a unique
identity code which can be cross referenced to a database of registered
406 MHz beacons, allowing the beacon’s owner or vessel to be immediately
identifi ed in the event of an emergency. Both models can be manually
activated by the operator in an emergency situation and will also
automatically activate out of the mounting bracket if fl oated in water.
Additionally each includes a ultra high performance solid state strobe
and 121.5 MHz VHF homing beacon to assist in leading rescuers to your
precise location.
The MT403G also features an intergrated 16 Channel GPS Receiver which
will automatically acquire a position and relay the latitude and longitude of
the beacon along with the personal identifi er and emergency signal.
ABOuT THE cOSPAS-SARSAT SySTEM
The COSPAS-SARSAT system is a complete global search and rescue service
using geostationary and polar orbiting satellites. Many countries provide
ground facilities known as Local User Terminals (LUTs).
Polar orbiting satellites provide complete, although non-continuous, coverage
of the earth (due to the fact that these satellites can only view a portion of
the earth at any given time) and can accurately resolve an active beacons
location. Additionally, geostationary satellites can give an immediate alerting
function in many regions of the world.
The basic COSPAS-SARSAT concept is illustrated in the fi gure above.
ABOuT 406 MHz BEAcONS
406 MHz beacons provide more accurate and reliable alert data to search
and rescue agencies than the older 121.5/243 MHz systems presently being
phased out. The older 121.5 MHz analogue system required that the satellite
be within view of both the beacon and the LUT before it could transmit
the beacons position. This limited the coverage to an area immediately
surrounding the LUT. However, the digital nature of the 406 MHz system
means that the satellites are able to store the beacons position and digital
message, no matter where in the world it is received. These details are then
relayed to the next LUT that comes into range, giving the 406 MHz system
true global coverage.
REGISTRATION AND TRANSFER OF OWNERSHIP
Registration of your 406 MHz satellite EPIRB with the Registration Section of
your National Authority is important because of the global alerting nature of
the COSPAS-SARSAT system.
Owner Registration Forms for registering your beacon may be supplied within
the packaging, otherwise, your National Authority will be able to provide the
correct forms. Up to date forms are often available online.
The information provided in the registration is used only for search and
rescue purposes. Promptly fi ll in the owner registration form upon completion
of the sales transaction, then mail, fax or email it to your National Authority.
If the beacon is to enter service immediately, complete the registration form
and fax or email the information.
Should the beacon be transferred to a new owner, as the previous owner
you are to inform your National Authority by email, fax, letter or telephone
of the name and address of the new owner.
The new owner of the beacon is required to provide their National Authority
with the information as shown on the registration form. This obligation
transfers to all subsequent owners.
NOTE: Your MT403/403G EPIRB has been programmed with a unique identifying
code which will be transmitted by the beacon in an emergency. Registering
your beacon provides the authorities with immediate access to your details
when the beacon is detected. This means they will know who you are, who your
emergency contacts are and what type of vessel or craft you are in. In situations
of accidental activation they can also immediately eliminate your beacon as an
emergency situation by contacting you when activation is detected.
PREVENTING AccIDENTAl AcTIVATION
The signal from an EPIRB is regarded by authorities as an indication of
distress and is given an appropriate response. It is the responsibility
of every owner of an EPIRB to ensure that it is not activated unintentionally
or in situations that do not justify its use.
Most cases of accidental transmission result from poor or inappropriate
storage or failure to totally disable an old model EPIRB before disposal.
The need to treat EPIRBs responsibly cannot be too highly emphasized.
The MT403/403G will not commence transmitting until approximately
60 seconds after activation, providing a safety period of audible and
visual warning. If you hear the beacon beeping while it is being carried
or stowed, you may still be able to deactivate it during this time period
without actually transmitting a distress signal. If in doubt, report the
incident to your local authorities just in case.
To minimize the possibility of accidental activation, EPIRB owners are urged
to pay careful attention to the following points:
1. Always stow the EPIRB in the mounting bracket and with the switch
cover closed. The mounting bracket and switch cover are designed
specifi cally to prevent accidental activation.
2. Avoid stowing the EPIRB where it may lie in water.
3. Avoid mounting the EPIRB where it will be subjected to continuous
direct sunlight. This could cause the beacon’s internal temperature
to exceed the maximum storage temperature of +70°C. Long term
stowage under these conditions could result in reduced battery life, poor
performance or degradation of the plastics due to excessive U.V. light.
4. Do not allow children to interfere with the EPIRB.
5. Educate others on board your vessel regarding the consequences of activation.
NOTE: Always stow the EPIRB in it’s bracket to minimise the possibility of an
accidental automatic activation in the presence of moisture. The yellow collar,
provided with this model‘s bracket, contains special features which temporarily
P/N: 310424 Dwg No: 44212-3 www.gme.net.au
Standard Communications
PTY LTD.
HEAD OFFIcE: Locked Bag 2086, North Ryde, N.S.W. 1670, Australia.
Tel: +61 (0)2 9844 6666 Fax: +61 (0)2 9844 6600
INTERNATIONAl ENquIRIES
International enquiries should be direccted to: [email protected]
NATIONAl AuTHORITy DETAIlS
Australia
24 hour Emergency contact
Phone: 1 800 641 792
Registration
Beacon Registration Section, AusSAR
Australian Maritime Safety Authority
GPO Box 2181, Canberra ACT 2601.
Fax: 1 800 406 329 Local Only.
Email: [email protected]
Web: www.amsa.gov.au
Phone: Freecall 1 800 406 406 Local only.
+61 2 6279 5766 Business hours only, local
or International. New Zealand
24 hour Emergency contact
Phone: +64 4 577 8030
Registration
Rescue Co-ordination Centre New Zealand
PO Box: 30050, Lower Hutt 5040
Fax: +64 4 577 8041
Email: [email protected]
Phone: +64 4 577 8033
NATIONAl DISTRIBuTOR DETAIlS BATTERy
Replacement Period: Prior to expiry date marked on case.
Replacement Method: Service centre, or factory only (non-user replaceable).
chemistry: LiMnO
2
(0.49 g Lithium per cell)
confi guration: 5 parallel packs each of 2 series cells.
PHySIcAl
Operating: -20°C to +55°C.
Storage: -30°C to +70°C.
Weight: 555 g (plus 98 g for bracket).
compass Safe
Distance: 0.7m (incl mounting bracket) from magnetic navigational
device when inactive.
Dimensions: 260 mm (H) x 102 mm (W) x 83 mm (D) max.
when stowed in bracket.
Materials: UV stabilized plastic chassis.
Performance: IEC 61097; IEC 60945; AS/NZS 4280.1; ETSI EN 300 066.
Transport class: Exempt from UN3091
Patent Number: GB2420058, other patents appiled for.
OTHER FEATuRES
GPS: Internal 16 channel high performance receiver with
quadrifi lar helix antenna (MT403G only).
Retention lanyard: Buoyant type approximately 5.5 metres long.
Refl ector: SOLAS retro-refl ective tape encircling unit above waterline.
Solid-state Strobe: High reliability solid state design exceeds IMO
requirements.
Antenna: Flexible self straightening stainless steel design.
Bracket: Quick release mechanism (manual). Retained by four (4)
vessel fi xing points.
* Standard factory setting, subject to National requirements. Distributor
re-programmable via optical data interface.
Specifi cations are subject to change without notice or obligation.
E M E R G E N C Y
POSITION INDICATING
R A D I O B E A C O N
E P I R B
406 MHz
Homer/Strobe
MT403
Water activation
MT403 MT403G
Patent Number: GB2420058
G P S V E R S I O N
M A N U A L & W A T E R
A C T I V A T I O N
MT403G
M A N U A L & W A T E R
A C T I V A T I O N
GPS antenna
GME SIX (6) yEAR WARRANTy
GME limit this warranty to the original purchaser of the equipment.
GME warrant this product to be free from defects in material and
workmanship for a period of 6 years from the date of purchase from
the authorised retailer.
Replacement of batteries due to expiry or usage is excluded from this Warranty.
Should the product require servicing during this period, all labour and parts
used to effect repairs will be supplied free of charge. GME reserve the right
to determine whether damage has been occasioned by accident, misuse or
improper installation, whereby the Warranty could be void.
In the event of a defect occurring during the Warranty period, the original
purchaser may return the defective unit along with suitable proof of purchase
(i.e. receipt, credit card slip etc.) and a full description of the defect to the
retailer from whom the unit was purchased. The retailer
will forward the unit to an authorised GME Service Depot in your State.
All freight charges incurred for transportation by the retailer or GME are
the purchasers’ responsibility.
Calls from a mobile attract connection charges.