Craftsman 486.24218 - Manual (Page 6)

6 Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
FIGURE 7
SWEEpERS WITH A SINGLE HITCH TUBE
BEARING BEARING
SPACER
CLAMP
NoTE: The dethatcher attaches to the sweeper's offset
tube. This prevents you from offsetting the sweeper.
FIGURE 8
1/2 x 3-1/2" HEX BOLT
1/2" NYLOCK
JAM NUT
• Assemble the four bearings to the two spacers and
then slide each through a clamp.
• Attach each of the bearing, spacer, and clamp
assemblies to a mount bracket using a 1/2 x 3-1/2" hex
bolt and 1/2" nylock jam nut.
3/32" HAIR
COTTER PIN
5/16" WASHER
5/16 x 1-3/8"
CLEVIS PIN
5/16" NYLOCK NUT
5/16" x 2-1/2"
HEX BOLT
FIGURE 9
FIGURE 10
FIGURE 11
DOUBLE TRANSPORT HOOK
• Fasten each clamp to the spring mount frame
assembly using one 5/16 x 1-3/8" clevis pin, 5/16"
washer, and 3/32" hair cotter pin.
• Secure the two mount brackets to the inner holes of the
drawbar offset tube of the sweeper using two 5/16 x
2-1/2" hex bolts and 5/16" nylock nuts.
• Place the double transport hook onto the sweeper hitch
tube. Lift up the front of the dethatcher and slide it into
the double hooks to secure it in the transport position.