Grant Instruments TXF200 Operating Manual - Manual (Page 3)

TX150 & TXF200 30424 V6
Operating Manual Page 2
www.grantinstruments.com
EN
Contents
Contents 2
1.0 Use of products 4
2.0 How to use this operating manual 4
3.0 Safety information 5
3.1 Safety compliance 5
3.2 Safety symbols 5
3.3 Safety warnings 5
4.0 Operating instructions 6
4.1 Unpacking instructions 6
4.2 Fitting controller to ST baths 6
4.3 Fitting the controller to P baths 7
4.4 Fitting the controller to custom baths 7
4.5 Removing the controller from the bridge plate 8
4.6 Recommended liquids 8
4.7 Installation 9
4.8 Electrical supply 9
4.9 Using accessory cooling (C1G, C2G, CW5) 9
5.0 Operating procedures 10
5.1 Operation 10
5.1.1 Liquid level 10
5.1.2 Operation above 60°C 10
5.1.3 Operation at low temperatures 10
5.1.4 Using the pump 10
5.1.5 Using the switch over relay output 11
5.1.6 Emptying the ST baths 12
5.1.7 Setting up and switching on 12
5.1.8 Power loss 12
5.2 Using the TX150 & TXF200 13
5.2.1 Front panel controls 13
5.2.2 Rear panel connections 14
5.2.3 Communications ports 14
5.2.4 Switched relay port 14
5.2.5 External probe input 14
5.2.6 Setting the over-temperature thermostat 15
5.2.7 Display. Explanation of home screen icons. 15
5.2.8 Description of user interface and controls 16
5.2.9 Setting the control temperature 16
5.2.10 Setting a pump speed (TXF200 only) 16
5.2.11 Running a bath preset 17
5.2.12 Running a countdown timer 17
5.2.13 Running a program 18
5.2.14 Activating standby mode 19
5.2.15 Accessing the settings menu 19
5.3 Viewing, editing and saving settings 21
5.3.1 Configuring a preset 21
5.3.2 Creating a program (TXF200 only) 22
5.3.3 Editing a program (TXF200 only) 24
5.3.4 Selecting a liquid type 25
5.3.5 Selecting a temperature probe type 26
5.3.6 Configuring high and low temperature alarms 27
5.3.7 Setting the buzzer volume level 30
5.3.8 Selecting a language 30
5.3.9 Relay test and configuration 31
5.3.10 Display rounding 32