Graph Tech Ghost - Manual (Page 26)

26
Required Tools
• Electric drill and 5/16” bit (12” long recommended) for
drilling hole between cavities and starting 13-pin jack
hole; 9/32” bit for adding optional pots; 5/64” bit for
13-pin jack mounting plate holes; and 1/4” bit for installing
optional QuickSwitches
• Small round needle file for pick guard notches
• Screw driver for changing saddles and setting intonation
• Phillips screw driver for removing pick guard or cavity cover
• Soldering iron (25W) for Acousti-Phonic 1/4” jack and
acoustic volume pot harnesses
• Wire stripper / cutter
• 3/8” chisel for shaping 13-pin jack hole
• Olfa or X-Acto knife
• Masking tape
Optional Tools
• Dremel and 1/8” cutting bit for pick guard notches
• Router and 3/8” bit for shaping 13-pin jack hole