Great Planes Escapade .61 GP/EP ARF - GPMA1201 - Manual (Page 7)

7
Left Wing
Right Wing
❏ ❏
5. Note the position of the servo arms in the sketch. Cut
off the other three unused arms from the aileron servo arm.
❏ ❏
6. Thread a nylon clevis approximately 20 turns onto the
threaded end of the 2-56 x 6" [152mm] wire and then slide
a silicone clevis keeper onto the wire. Install the clevis into
the control arm as shown in the photograph. Slide the clevis
keeper over the clevis.
❏ ❏
7. Making sure the servo and the aileron are centered,
use a fi ne-point felt-tip pen to mark the pushrod wire where
it crosses the outer hole in the servo arm.
❏ ❏
8. Make a 90° bend in the wire at the mark. Enlarge
the holes in the aileron servo arm with a #48, 5/64" (.076"
[1.9mm]) drill or a hobby knife. Fit the pushrod into the outer
hole in the servo arm and then attach a 90° pushrod connector
to the assembly. Cut the excess wire 1/16" [2mm] above the
connector. Install the servo arm screw and slip the silicone
retainers over the pushrod.
❏
9. Repeat steps 1– 8 for the other wing.