Great Planes Escapade MX GP/EP ARF - GPMA1202 - Manual (Page 7)

7
❏ ❏
6. Thread a nylon clevis approximately 20 turns onto the
threaded end of the 2-56 x 6" [152mm] wire and then slide
a silicone clevis keeper onto the wire. Install the clevis into
the control arm as shown in the photograph. Slide the clevis
keeper over the clevis.
❏ ❏
7. Making sure the servo and the aileron are centered,
use a fi ne-point felt-tip pen to mark the pushrod wire where
it crosses the outer hole in the servo arm.
❏ ❏
8. Make a 90° bend in the wire at the mark. Fit the
pushrod into the outer hole in the servo arm and then attach
a 90° pushrod connector to the assembly. Cut the excess wire
1/16" [2mm] above the connector. Install the servo arm screw
and slip the silicone retainers over the pushrod.
❏
9. Repeat steps 1– 8 for the other wing.
ASSEMBLE THE FUSELAGE
Install the Elevator and Rudder
❏
1. Cut the balsa block free from the stabilizer opening with
a hobby knife.
❏
2. Slide the horizontal stabilizer (stab) into the stab opening
in the back of the fuselage.