Great Planes Lanier RC Stinger II - GPMA1010 - Manual (Page 8)

8
❏
11. Mix up a small batch of epoxy (6-minute epoxy will
work fi ne) and coat the grooved ends of the nylon anti-
rotation pins. Insert the pins into the root ribs of the wing
panels leaving the smooth ends protruding out 1/2" [13mm].
Wipe away any excess epoxy using a cloth dampened with
denatured alcohol and allow the epoxy to cure undisturbed.
ASSEMBLE THE TAIL SECTION
❏
1. Insert the wing tube into the fuselage and center it left
and right.
❏
2. Fit the wings onto the wing tube. The aileron servo
leads should pass through the cutouts in the fuse sides and
the anti-rotation pins fi t into their mating holes in the fuse.
Use the included nylon wing bolts to tighten the wings to the
fuselage.
❏
3. Test fi t the horizontal stabilizer into the stab slot in the
fuselage.
❏
4. Insert the vertical fi n into the slot on the top of the
fuselage. The tab at the bottom of the fi n fi ts into the slot in
the stabilizer which will align the position of the stabilizer in
the fuselage.