Great Planes P-51 Mustang GP/EP ARF - GPMA1205 - Manual (Page 16)

16
❏
8. Test fi t your batteries onto the tray. Adjust the lengths of
the straps if necessary.
❏
9. Trim the covering from the cool air exit hole on the
underside of the fuselage just behind the wing saddle.
FINISH THE MODEL
❏
1. Make a strap from the included hook and loop material
to fi t your receiver. Cut a piece of foam rubber (not included)
to fi t your receiver and strap the receiver to the radio tray as
shown. Connect the rudder, elevator and throttle servos (or
ESC if applicable) to the receiver.
❏
2. Mount your radio switch to the fuselage side in the
location that you prefer. We mounted ours below the aft bottom
edge of the battery hatch opening. We installed a charge jack
receptacle on the other side of the fuselage.
❏
3. If you have installed a glow engine, install the removable
hatch by fi tting the two dowels into the holes in the fi rewall.
Then, slide the hatch back. Secure the hatch in place by
threading two 2.5x8mm self-tapping screws through the pre-
drilled holes in the fuselage and into the hatch.